[IoCtl]
; This is the list of IoCtl identifiers used. These identifiers
; should be identical to the identifiers used by the application
; calling the DLL.
; Note: The 'xxxxx2' definitions are identical to the original
;       definitions except that they accept a pointer to the value
;       instead of the value itself.
FE_GET_INFO=                $80A86F3D   ; -2136445123
FE_DISEQC_RESET_OVERLOAD=   $00006F3E   ; 28478
FE_DISEQC_SEND_MASTER_CMD=  $40076F3F   ; 1074229055
FE_DISEQC_RECV_SLAVE_REPLY= $800C6F40   ; -2146668736
FE_DISEQC_SEND_BURST=       $00006F41   ; 28481
FE_DISEQC_SEND_BURST2=
FE_SET_TONE=                $00006F42   ; 28482
FE_SET_TONE2=
FE_SET_VOLTAGE=             $00006F43   ; 28483
FE_SET_VOLTAGE2=
FE_ENABLE_HIGH_LNB_VOLTAGE= $00006F44   ; 28484
FE_ENABLE_HIGH_LNB_VOLTAGE2=
FE_READ_STATUS=             $80046F45   ; -2147193019
FE_READ_BER=                $80046F46   ; -2147193018
FE_READ_SIGNAL_STRENGTH=    $80026F47   ; -2147324089
FE_READ_SNR=                $80026F48   ; -2147324088
FE_READ_UNCORRECTED_BLOCKS= $80046F49   ; -2147193015
FE_SET_FRONTEND=            $40246F4C   ; 1076129612
FE_GET_FRONTEND=            $80246F4D   ; -2145095859
FE_GET_EVENT=               $80286F4E   ; -2144833714

[FrontEnd]
  ;   LogLevel
  ;   The log file 'FlexCopFrontEnd.log' is used for logging data
  ;   were the type of messages send to this log file is set by this level
  ;    0: No log (debug) messages to log file
  ;    1: -
  ;    2: Errors
  ;    3: Main procedures/functions
  ;    4: Sub procedures/functions
  ;    5: Intermediate messages
  ;   Note: Only valid if the DLL supports it.
LogLevel=5

  ;   LogClear
  ;   'Yes' clears the log (only when logging active)
  ;   'No'  appends messages to the log
LogClear=Yes
